MSHA – Mine Fatality #34

MINE FATALITY – On August 18, 2023, a section foreman was installing hose for a dewatering pump.  He was found unresponsive lying in approximately eight inches of water and mud.  The death certificate listed the cause of death as drowning.

Accident scene where a section foreman was installing hose for a dewatering pump. 
Photo property of MSHA
Best Practices
  • Provide and maintain safe access to all working places.  Remove standing water where miners work and travel.
  • Ensure qualified electricians examine and maintain electrical equipment in safe operating condition; if equipment is defective, correct hazards or remove equipment from service.
  • Report and correct any slip, trip, or fall hazards.
Additional Information

This is the 34th fatality reported in 2023, and the second classified as “Drowning.”


McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

MSHA – Mine Fatality #31

MINE FATALITY – On September 8, 2023, a miner died after entering a hopper to clear an obstruction.  A front-end loader dumped two loads of crushed limestone into the hopper with the miner inside.

Accident scene where a miner died after entering a hopper to clear an obstruction.
Photo property of MSHA
Best Practices
  • Install barricades to prevent mobile equipment access to bins and hoppers when miners are working in them.
  • Establish and train miners on procedures for safely clearing bins and hoppers.
  • Lock-out and tag-out the supply and discharge equipment before entering bins and hoppers.
  • Wear a safety belt or harness equipped with a lifeline in a confined space.
  • Equip bins and hoppers with vibrating shakers or air cannons to prevent material blockages.
Additional Information

This is the 31st fatality reported in 2023, and the seventh classified as “Powered Haulage.”


McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

New OSHA resource: Heat exposure and personal risk factors

hot-work2.jpg

Photo: HadelProductions/iStockphoto

Washington — Certain personal risk factors increase workers’ risk for heat-related injury and illness, OSHA cautions.

“Although you may be exposed to similar levels of heat and engaged in the same type of work as your co-workers, personal risk factors” such as health conditions, medications, and physical and behavioral characteristics “may cause you to be at greater risk,” the agency says in a recently published document.

Conditions or medications that can cause a worker to be less likely to sense heat conditions or retain water include:

  • Diabetes
  • High blood pressure
  • Heart disease
  • Obesity
  • Mental health conditions
  • Respiratory diseases such as asthma or chronic obstructive pulmonary disease
  • Blood pressure medications
  • Muscle relaxants
  • Sedatives

Additionally, some physical or behavioral characteristics may cause a worker to dehydrate more quickly. These include:

  • Age (60 and older)
  • Lower level of physical fitness
  • Pregnancy
  • Acclimatization status
  • Lower intake of water
  • Alcohol use within 24 hours of shift
  • Use of illicit drugs, such as opioids, methamphetamine and cocaine

“Ultimately,” OSHA says, “it is the employer’s responsibility to ensure the workplace is safe and healthful for workers; however, a heat injury and illness prevention plan needs the meaningful participation of workers and their representatives to be effective.”

The agency has tips to help keep workers safe in the heat:

  • Discuss with your medical provider how to best prepare to work in hot conditions.
  • Drink 8 ounces of water every 15-20 minutes, even if you aren’t thirsty.
  • Notify your supervisor if you feel ill and move to a cool space.
  • Take rest breaks in air-conditioned spaces or cool or shaded areas.
  • Check on co-workers regularly; report signs of heat illness to a supervisor, and provide water or ice while remaining with them until help arrives.
  • Wear loose-fitting, light-colored clothing comprised of breathable fabric, like cotton.
  • Know your employer’s emergency response plan; when in doubt, call 911.
  • Gradually acclimatize to the heat when returning to work after time away.

McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by Safety+Health an NSC publication

Employers: Do your workers use respirators? NIOSH wants to know

respirator.jpg
Image: U.S. Navy

Washington — NIOSH wants to update its estimate of the number of organizations and workers who use respirators – and evaluate the reasons behind their use.

The Survey of Respirator Use and Practices marks NIOSH’s first effort to collect national, industrywide data on respiratory protection since 2001. In a press release, NIOSH cites a need to update its Respirator Approval Program, as awareness and use of respirators has expanded amid the COVID-19 pandemic and its aftermath.

“Respirators offer workers and the public protection from hazards such as those created when providing health care to patients, using harsh chemicals for cleaning or manufacturing, or fighting wildland or structural fires,” Maryann D’Alessandro, director of NIOSH’s National Personal Protective Technology Laboratory, said in the release. “We encourage all businesses to complete the survey about their respirator use and practices. This information is critical to informing future research and development within NIOSH’s Respirator Approval Program.”

NIOSH plans to begin contacting employers regarding the survey on Nov. 2. Questions? Email ODAdmin@cdc.gov.


McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by Safety+Health an NSC publication

MSHA – Mine Fatality #35

MINE FATALITY – On October 2, 2023, a miner died after he was pinned between a shuttle car and a coal rib.

Accident scene where a miner died after he was pinned between a shuttle car and a coal rib.
Photo property of MSHA
Best Practices
  • When working around mobile equipment, communicate your presence and intended movements to equipment operators. Wait for acknowledgement before moving.
  • Avoid “Red Zone” areas where equipment operators cannot readily see you.
  • Increase the visibility of miners by using reflective clothing and/or strobe light devices.
Additional Information

This is the 35th fatality reported in 2023, and the tenth classified as “Powered Haulage.”


McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

Water Related – Safety Alert

Water-Related Fatalities on the Rise

5 water-related fatalities since 2022
Hazards of Working Around, Over, or Near Water 

HAZARDS – undercut banks, sloughing ground, varied water depth, swift currents, inadequate berms, narrow roadways
POTENTIAL DANGER – Entrapment, Entanglement, Drowning,

Electrocution RISKS – Traveling, operating mining equipment, around, over, or near water

Best Practices
  • Conduct daily workplace examinations.
  • Know the water depth and subsurface conditions and ground conditions before you begin work.
  • Keep equipment a safe distance back from the water’s edge.
  • Provide handrails around docks and work boats.
  • Properly berm roadways near water hazards.
  • Provide and ensure workers wear a Coast Guard approved Type I or Type V personal flotation device (PFD) when working around water.
  • Keep water rescue equipment easily accessible.
  • Practice good housekeeping and keep all travel ways clear around water hazards.
  • Post warning signs near water hazards.


McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

Three Bulldozer Fatal Accident – Safety Alert

Three bulldozer related fatalities

A bulldozer operator was fatally injured when the bulldozer he was operating rolled down a 375 feet embankment. A second bulldozer operator was fatally injured when the bulldozer he was operating rolled down a 300 feet embankment. A third bulldozer operator was fatally injured when the bulldozer backed over the edge of a highwall. In all three accidents the operator was not wearing a seatbelt.

In all three accidents the operator was not wearing a seatbelt.
Photo property of MSHA
Best Practices
  • Conduct workplace examinations prior to beginning work.
  • Maintain control and stay alert when operating mobile equipment.
  • Wear seat belts when operating equipment.
  • Train Miners to perform task safely and to recognize potential hazards.

McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

Machinery – Safety Alert

Ten Machinery Fatal Accidents 

Ten machinery accidents occurred.  These fatal accidents involved three bulldozers, a haul truck tire’s locking ring that dislodged and struck a miner, and the side plate of a shaker screen that fell during disassembly and struck a miner.  It also includes two truck drivers who were fatally struck, and three miners who were struck while equipment lifts were being performed.

(Left to Right) Shaker screen disassembly. Bulldozer rolled down an embankment. Locking Ring dislodged from truck wheel. Bulldozer rolled down an embankment.
Photo property of MSHA
Best Practices
  • Maintain equipment in safe operating condition.
  • Examine work areas prior to beginning work and operating heavy equipment.
  • Operate equipment on stable ground and away from hazards.
  • Maintain control of equipment and stay alert.
  • Always wear seatbelts: remain inside the cab; never attempt to jump clear; consider the use of four-point seat belt systems and new technology that provides early warning of tipping.
  • Provide adequate means to prevent locking rings (rims) from creating a hazard. Use tire cages and deflate tires before conducting repairs.
  • Train miners to safely perform task.

McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

Dipper Bucket – Safety Alert

Maintenance Hazard on Dipper Buckets

A miner died when a 13-ton steel dipper door he was working on closed, crushing him between the dipper door and the edge of the bucket. Maintenance work on a dipper bucket’s door when it is separated from the bucket is dangerous. Make sure to always have a redundant blocking mechanism when performing such work.

Maintenance hazard on dipper buckets
Photo property of MSHA
Best Practices
  • Make sure miners are positioned in a safe location and away from potential pinch point areas.
  • Securely block equipment against motion before beginning maintenance or repairs.
  • Assure blocking material is substantial and installed correctly to support and stabilize the load.
  • Make sure miners conduct repairs according to manufacturer’s recommendations.

McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA

Working Alone – Safety Alert

working alone safety alert
Photo property of MSHA
Best Practices
  • Evaluate the assigned task
    • Do you have adequate training, knowledge, skills and equipment to do the job safely?
    • Do you need help to complete the task safely?
  • Always inform a responsible person where you will be working or traveling in the mine
  • Identify hazards
  • Correct and isolate the hazard(s) or report the hazard(s) to your supervisor
  • Always use the proper tools and equipment to do the job
  • Don’t take shortcuts, do the job safely
  • Follow established communications procedures
  • Use established check-in/check-out procedures
  • It’s your safety! Protect it!

McCraren Compliance offers a full range of safety and health training and consulting services. Plus we can help you incorporate well-being into your traditional systems in order to support the Total Worker Health of your workforce.

Call 888-758-4757, email info@mccrarencompliance.com or visit our website www.mccrarencompliance.com

Original article published by MSHA