3M gives update on recent recall of fall protection devices

Red Wing, MN — 3M Co. has resolved an issue with the energy absorber on one of its recalled fall protection devices, the organization announced Aug. 6. The solution, however, is available only in regions that recognize ANSI standard Z359.14.

3M recently issued an immediate recall and stop-use alert for the DBI-SALA Twin-Leg Nano-Lok Edge and Wrap Back Twin-Leg Self-Retracting Lifelines. The energy absorbers on both devices were susceptible to not deploying in a proper manner, potentially putting workers at risk of serious injury or death, the alert states.

3M announced that it resolved the partial deployment of the energy absorber on its DBI-SALA Twin-Leg Nano-Lok Edge device, but that solution is limited so far.

“Due to regional regulatory requirements, this solution is currently available ONLY in regions that recognize the ANSI standard,” 3M states. “As other regulatory certifications are received, this solution will be made available in those regions. Until your unit has been repaired or replaced, the ‘Stop Use and Recall’ remains in effect and these units must be removed from service.”

The alert informs customers that the fall protection device is safe to use if it has a green check mark on the front label, adding that the mark means the unit “has either been repaired or has come from the factory with the revision and is certified for its intended use.”

3M is offering to repair or replace affected devices for free, or will issue a refund. To file a claim, go to nanolokedgerecall.com. Product numbers of affected devices are listed on the website.

For questions, call 3M’s customer service department at (833) 638-2697 or email 3musfpserviceaction@mmm.com.

STOP USE of 3M DBI-SALA Nano-Lok Edge and Wrap Back Twin-Leg Self Retracting Lifelines

3M Fall Protection has announced an immediate stop use and product recall of the 3M™ DBI-SALA® Nano-Lok™ edge and Wrap Back Twin-Leg Self Retracting Lifelines. The twin-leg Nano-Lok edge is part of a personal fall protection system and connects two self-retracting lifelines/devices (SRL’s/SRD’s) directly under the dorsal d-ring of a worker’s harness. It is intended to be anchored at foot-level, and is designed for sharp edge applications. The twin-leg Wrap Back Nano-Lok is intended for wrapping around an anchor and incorporates a similar energy absorber. 3M has determined that in the event of a fall and under certain conditions, the energy absorber may not properly deploy which could expose the worker to serious injury or death.

RECALL NOTICE